Controls Chevrolet Traverse
Steering Wheel Controls
Heated Steering Wheel
Horn
Windshield Wiper/Washer
Rear Window Wiper/Washer
Compass
Clock
Power Outlets
Wireless Charging
Steering Wheel Adjustment.
To adjust the steering wheel:.
● Pull the lever down.
● Move the steering wheel up or down.
● Pull or push the steering wheel closer or away from you.
● Pull the lever up to lock the steering wheel in place.
Do not adjust the steering wheel while driving.
Power Tilt and Telescoping Steering Wheel.
If equipped, the control is on the left side of the steering column.
● Push the control up or down to tilt the steering wheel up or down.
● Push the control forward or rearward to move the steering wheel toward the front or rear of the vehicle.
Do not adjust the steering wheel while driving.
Steering Wheel Controls.
The infotainment system can be operated by using the steering wheel controls. See Steering Wheel Controls 0 142.
Heated Steering Wheel.
( : If equipped, press to turn it on or off.
A light next to the button displays when the feature is turned on.
The steering wheel takes about three minutes to reach maximum heat.
Automatic Heated Steering Wheel.
If equipped with remote start, the heated steering wheel may turn on automatically during a remote start along with the heated seats when it is cold outside. The heated steering wheel indicator light may not come on.
If equipped with auto heated seats, the heated steering wheel may turn on when the auto heated seat is activated. The heated steering wheel indicator will follow the state of the steering wheel heat.
See Heated and Ventilated Front Seats 0 42 and.
Vehicle Personalization 0 125.
Horn.
Pressaon the steering wheel pad to sound the horn.
Windshield Wiper/Washer.
With the ignition on or in ACC/ACCESSORY, move the windshield wiper lever to select the wiper speed.
HI : Use for fast wipes.
LO : Use for slow wipes.
INT : Move the windshield wiper lever to.
INT. Turn the band up for more frequent wipes or down for less frequent wipes.
OFF : Use to turn the wipers off.
1. X : For a single wipe, briefly move the wiper lever down. For several wipes, hold the wiper lever down.
f: Pull the windshield wiper lever toward you to spray windshield washer fluid and activate the windshield wipers. The wipers will continue until the lever is released or the maximum wash time is reached. When the windshield wiper lever is released, additional wipes may occur depending on how long the windshield washer had been activated. See Washer.
Fluid 0 281 for information on filling the windshield washer fluid reservoir.
⚠ Warning.
In freezing weather, do not use the washer until the windshield is warmed.
Otherwise the washer fluid can form ice on the windshield, blocking your vision.
⚠ Warning.
Before driving the vehicle, always clear snow and ice from the hood, windshield, washer nozzles, roof, and rear of the vehicle, including all lamps and windows.
Reduced visibility from snow and ice buildup could lead to a crash.
Clear snow and ice from the wiper blades and windshield before using them. If frozen to the windshield, carefully loosen or thaw them. Damaged blades should be replaced.
See Wiper Blade Replacement 0 285.
Heavy snow or ice can overload the wiper motor. See Electrical System Overload 0 288.
Wiper Parking.
If the ignition is turned off while the wipers are on LO, HI, or INT, they will immediately stop.
If the windshield wiper lever is then moved to OFF before the driver door is opened or within 10 minutes, the wipers will restart and move to the base of the windshield.
If the ignition is turned off while the wipers are performing wipes due to windshield washing, the wipers continue to run until they reach the base of the windshield.
Rear Window Wiper/Washer.
The rear window wiper/washer controls are on the end of the windshield wiper lever.
Turn the controls to adjust the setting.
OFF : Turns the wiper off.
INT : Turns on the rear wiper with a delay between wipes.
ON : Turns on the rear wiper.
1. : Push the windshield wiper lever forward to spray washer fluid on the rear window. The wipers will clear the rear window and either stop or return to your preset speed. For more washer cycles, press and hold the lever.
The rear window wiper/washer will not operate if the liftgate is open or ajar. If the liftgate is opened while the rear wiper is on, the wiper returns to the parked position and stops.
Rear Wiper Arm Assembly Protection.
When using an automatic car wash, move the rear wiper control to OFF to disable the rear wiper. In some vehicles, if the transmission is in N (Neutral) and the vehicle speed is very slow, the rear wiper will automatically park.
The wiper operations return to normal when the transmission is no longer in N (Neutral) or the vehicle speed has increased.
Reverse Gear Wipes.
If the rear wiper control is off, the rear wiper will automatically operate continuously when the vehicle is in.
R (Reverse) and the front windshield wiper is performing low or high speed wipes. If the rear wiper control is off, the vehicle is in.
R (Reverse), and the front windshield wiper is performing interval wipes, then the rear wiper automatically performs interval wipes.
This feature can be turned on or off. See.
Vehicle Personalization 0 125.
The windshield washer reservoir is used for the windshield and the rear window. Check the fluid level in the reservoir if either washer is not working. See Washer Fluid.
0. 281.
Rear Camera Washer.
If equipped, push the windshield wiper lever forward to spray washer fluid on the rear camera lens. The lever returns to its starting position when released. See Rear Camera.
Mirror 0 28.
Compass.
The vehicle may have a compass display on the Driver Information Center (DIC). The compass receives its heading and other information from the Global Positioning.
System (GPS) antenna, StabiliTrak/Electronic.
Stability Control (ESC), and vehicle speed information.
The compass system is designed to operate for a certain number of miles or degrees of turn before needing a signal from the GPS satellites. When the compass display shows.
CAL, drive the vehicle for a short distance in an open area where it can receive a GPS signal. The compass system will automatically determine when a GPS signal is restored and provide a heading again.
Clock.
Set the time and date using the infotainment system. See “Time/Date” under.
Settings 0 174.
Power Outlets.
Power Outlets 12-Volt Direct Current.
The vehicle has two 12-volt outlets that can be used to plug in electrical equipment, such as a tablet or MP3 player.
Center Stack.
Rear Cargo Area.
The power outlets are located:.
● On the center stack below the climate controls.
● In the rear cargo area.
Lift the cover to access the outlet and replace when not in use.
⚠ Warning.
Power is always supplied to the rear cargo power outlet. Do not leave electrical equipment plugged in when the vehicle is not in use because the vehicle could catch fire and cause injury or death.
Caution.
Leaving electrical equipment plugged in for an extended period of time while the ignition is in LOCK/OFF will drain the battery. Always unplug electrical equipment when not in use and do not plug in equipment that exceeds the maximum 15 ampere rating.
Certain accessory plugs may not be compatible with the accessory power outlet and could overload vehicle and adapter fuses. If a problem is experienced, see your dealer.
When adding electrical equipment, be sure to follow the proper installation instructions included with the equipment. See Add-On.
Electrical Equipment 0 268.
Caution.
Hanging heavy equipment from the power outlet can cause damage not covered by the vehicle warranty. The power outlets are designed for accessory power plugs only, such as cell phone charge cords.
Power Outlet 110V/120V Alternating.
Current.
If equipped with this power outlet it can be used to plug in electrical equipment that uses a maximum limit of 150 watts.
The power outlet is on the rear of the center console.
An indicator light on the outlet turns on to show it is in use. The light comes on when the ignition is on, equipment requiring less than 150 watts is plugged into the outlet, and no system fault is detected.
The indicator light does not come on when the ignition is off or if the equipment is not fully seated into the outlet.
If equipment is connected using more than.
15. 0 watts or a system fault is detected, a protection circuit shuts off the power supply and the indicator light turns off. To reset the circuit, unplug the item and plug it back in or turn the Retained Accessory Power.
(RAP) off and then back on. See Retained.
Accessory Power (RAP) 0 218. The power restarts when equipment using 150 watts or less is plugged into the outlet and a system fault is not detected.
The power outlet is not designed for and may not work properly, if the following are plugged in:.
● Equipment with high initial peak wattage, such as compressor-driven refrigerators and electric power tools.
● Other equipment requiring an extremely stable power supply, such as microcomputer-controlled electric blankets and touch sensor lamps.
● Medical equipment.
See High Voltage Devices and Wiring 0 288.
Wireless Charging.
If equipped and enabled, the vehicle has wireless charging in the storage bin in front of the floor console. The system operates at.
14. 5 kHz and wirelessly charges one Qi compatible smartphone. The power output of the system is capable of charging at a rate up to 3 amp (15 W), as requested by the compatible smartphone. See Radio.
Frequency Statement 0 361.
⚠ Warning.
Wireless charging may affect the operation of an implanted pacemaker or other medical devices. If you have one, it is recommended to consult with your doctor before using the wireless charging system.
The vehicle must be on, in ACC/ACCESSORY, or Retained Accessory Power (RAP) must be active. The wireless charging feature may not correctly indicate charging when the vehicle is in RAP, during a Bluetooth phone call, or when phone projection (e.g. Apple.
CarPlay / Android Auto) is active. See.
Retained Accessory Power (RAP) 0 218.
The operating temperature is −40 °C (−40 °F) to 85 °C (185 °F) for the charging system and.
0. °C (32 °F) to 35 °C (95 °F) for the phone.
A charging stopped alert may be displayed on the infotainment screen, if the wireless charger or smartphone are outside of normal operating temperature. Charging will automatically resume when a normal operating temperature is reached.
⚠ Warning.
Remove all objects from the charger before charging your compatible smartphone. Objects, such as coins, keys, rings, paper clips, or cards, between the smartphone and charger may become very hot.
On the rare occasion that the charging system does not detect an object, and the object gets wedged between the smartphone and charger, remove the smartphone and allow the object to cool before removing it from the charger, to prevent burns.
To charge a compatible smartphone:.
● Confirm the smartphone is capable of wireless charging.
● Remove all objects from the charging pad. The system may not charge if there are any objects between the smartphone and charger.
● Place the smartphone face up against the rear of the charger.
To maximize the charge rate, ensure the smartphone is fully seated and centered in the holder with nothing under it.
A thick smartphone case may prevent the charger from working, or reduce the charging performance. See your dealer for additional information.
● A green ] will appear on the infotainment display, next to the phone icon. This indicates that the smartphone is detected.
● If a smartphone is placed on the charger and ] turns off or turns yellow, remove the smartphone and any objects from the pad. Turn the smartphone.
18. 0 degrees and wait a few seconds before placing/aligning it on the pad again.
● If a smartphone is placed on the charger and ] turns red, the charger and/or the smartphone is overheated. Remove the smartphone and any objects from the charger in order to cool the system.
The smartphone may become warm during charging. This is normal. In warmer temperatures, the speed of charging may be reduced.
For vehicles with wireless phone projection, the smartphone may overheat during wireless charging. The smartphone may slow down, stop charging, or shut down to protect the battery. The phone may need to be removed from its case to prevent overheating. The ] may flash while the phone is cooling down enough for wireless charging to automatically resume. This is normal. Individual phone performance may vary.
Software Acknowledgements.
Certain Wireless Charging Module product from LG Electronics, Inc. (“LGE”) contains the open source software detailed below. Refer to the indicated open source licenses (as are included following this notice) for the terms and conditions of their use.
OSS Notice Information.
To obtain the source code that is contained in this product, please visit https://opensource.lge.com. In addition to the source code, all referred license terms, warranty disclaimers and copyright notices are available for download. LG Electronics will also provide open source code to you on CD-ROM for a charge covering the cost of performing such distribution (such as the cost of media, shipping, and handling) upon email request to opensource@lge.com. This offer is valid for three (3) years from the date on which you purchased the product.
Freescale-WCT library.
Copyright (c) 2012-2014 Freescale.
Semiconductor, Inc.. All rights reserved.
Redistribution and use in source and binary forms, with or without modification, are permitted provided that the following conditions are met:.
● Redistributions of source code must retain the above copyright notice, this list of conditions and the following disclaimer.
● Redistributions in binary form must reproduce the above copyright notice, this list of conditions and the following disclaimer in the documentation and/or other materials provided with the distribution.
● Neither the name of the copyright holder nor the names of its contributors may be used to endorse or promote products derived from this software without specific prior written permission.
THIS SOFTWARE IS PROVIDED BY THE COPYRIGHT HOLDERS AND CONTRIBUTORS AS IS AND ANY EXPRESS OR IMPLIED WARRANTIES, INCLUDING, BUT NOT LIMITED TO, THE IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE ARE DISCLAIMED. IN NO EVENT SHALL THE COPYRIGHT HOLDER OR CONTRIBUTORS BE LIABLE FOR ANY DIRECT, INDIRECT, INCIDENTAL, SPECIAL, EXEMPLARY, OR CONSEQUENTIAL DAMAGES (INCLUDING, BUT NOT LIMITED TO, PROCUREMENT OF SUBSTITUTE GOODS OR SERVICES; LOSS OF USE, DATA, OR PROFITS; OR BUSINESS INTERRUPTION) HOWEVER CAUSED AND ON ANY THEORY OF LIABILITY, WHETHER IN CONTRACT, STRICT LIABILITY, OR TORT (INCLUDING NEGLIGENCE OR OTHERWISE) ARISING IN ANY WAY OUT OF THE USE OF THIS SOFTWARE, EVEN IF ADVISED OF THE POSSIBILITY OF SUCH DAMAGE.
